We must be very careful when removing these parts of poultry feed pellet machine, do not make scratches on the surface of these parts, if the scratches are made carelessly, this part will appear abnormal noise when working, serious It will stop working. In addition to paying attention to these problems when disassembling, we should also pay more attention when assembling the poultry feed mill. First, when assembling the gears of this machine, we must see clearly that the crankshaft of this machine is It's not very clean, if not clean.
We need to use a softer rag or a new towel to remove the oil and impurities on it, and then apply a layer of oil on the crankshaft, so as to ensure that the crankshaft is rotating. There will be no interference phenomenon, and when we install this gear, we must be optimistic about the gear's occlusal direction. We must install along the gear's occlusal direction. If we do not follow the gear's occlusal direction. If it is installed, the gear may break when the pellet machine rotates. When installing gears, apart from clarifying these directions, it is more important to look at the bite density of these gears. The bite density of these gears will change with the tightness of our screws. Only if we carefully install our small feed making machine will it not be hurt!
No comments:
Post a Comment